| 1. | Feeding system adopts cnc servo motor , bending angle uses cnc control
采用数控伺服电机进料系统，数控折弯角度控制系统。 |
| 2. | Discussion on the approximate calculation method for the space bending angle in continuous curved bridge
预压在处理桥梁沉降中的运用 |
| 3. | Inversion of earth ' s neutral atmospheric parameters and bending angles with gps occultation data
掩星资料反演地球中性大气参数折射角方法研究 |
| 4. | The temperature and the deformation fields of the forming process were calculated and the final bending angle was predicted
计算了弯曲成形过程的温度场及变形场，预测了钢板的最终弯曲角度。 |
| 5. | The accessional loss due to bend is also very small . while the bend angle is 90 degree , the accessional loss is less than idb / m
Sdb m ，且弯曲附加损耗较小，在弯曲角度为90度时，附加损耗小于ldb m 。 |
| 6. | In order to achieve a large bending angle meanwhile not to increase the outer diameter too much , the catheter consists of several bending units
为了实现较大弯曲角度而不过多增加整体外径,采用多个弯曲单元串联的形式。 |
| 7. | The key factors affecting the stagnation point position of l - type pipeline section are the setting position of bellows type expansion joint and the bend angle degree
影响水平转角管段驻点位置的主要因素为波纹管补偿器设置位置、弯头角度。 |
| 8. | The formulae for calculating the bend radius of neutral plane and the decrement of bend angle after springback were derived by considering the deformation after unloading
依据卸载变形的分析计算，推导出回弹后中性层弯曲半径及弯曲角变化量的计算公式。 |
| 9. | Field application result shows that for eccentric screw stabilizer , there exist errors of calculated outside diameters and measured diameters , the upper stabilizer has severe influence on side force of drilling bits , and it can be optimally designed , while the bending angle of screw also has severe influence on bit side force , and it should be rationally used
现场使用结果表明，螺杆本体稳定器采用偏心式时计算外径与丈量直径存在偏差；上稳定器对钻头侧向力具有较大的影响，可以优化设计；螺杆弯角对钻头侧向力影响较大，需合理使用。 |
| 10. | There ' s one other alternative - one that takes both skilled and courage : forgoing any cradling action , grasp the cone more firmly between thumb and forefinger and extend the other fingers so that they are out of the way of the dripping from the bottom , then increase the waist - bend angle from twenty - five to thirty - five degrees , and then eat the cone , allowing it to drip out of the bottom onto the ground in front of you
还有另一种选择,但那既需要技巧也需要勇气,即:在进行任何补救措施之前,以拇指和食指牢牢夹住蛋筒,并翘起其他手指以免粘上蛋筒底端的冰激凌,然后上身倾度由25度变为35度,再吃蛋筒,随它在你跟前漏洒到地上 |
